DataWave Technologies - Data Acquisition and Data Analysis
Home Products Applications Company New! Contact Us
AM-3500 Extracellular Amplifier

The AM-3500 moves you out of the past and into the future of multiple channel amplifiers.   It gives you "true differential" amplification on each of the 16 channels.   And is designed to interface directly to the electrode without a headstage.
The amplifier's powerful features can be accessed via software or accessed at the device using an easy-to-use touch panel interface.   The AM-3500 has all of the features you could possibly need for extracellular recording.
See also the AM-3600 for a similar amp that is compatible with various headstages.
AM-3500 Key Features
- 16 independent high gain, low noise channels
- Select from either a common reference or "true" differential recording with a separate reference on each channel
- A wide range of high pass, low pass, and notch filters
- Pass stimulation current to any or all channels
- Hardware stimulus blanking
- Built-In output monitors and calibration signals
- Control via touch screen or compatible software program
- Store amplifier settings in the amplifier or on the computer
- Link multiple amplifiers together for higher channel counts (32, 64, 128 etc.)
- Optional software control directly from DataWave SciWorks
- Can be rack mounted
AM-3500 Specifications
Noise:  Voltage, fB = 10Hz-10kHz, typical: 1.0µV, rms
Offset Voltage:  Average Drift, typical: ±4.0µV/Deg C
Average Drift, maximum: ±30.0µV/Deg C
Bias Current:  Initial Bias Current, maximum: ±0.4nA
Offset Current:  Input Offset Current, maximum: ±0.4nA
Input Impedance:  1012Ω || 4pF
Inter-Channel Crosstalk:  100dB at 1kHz
Input Voltage Size:  VDC: 1 Volt
VAC: Gain / 10 Volts
Common Mode Rejection (CMR): 100dB
Rated Output:  Voltage Output: ±11V
Output Resistance: >100Ωs
Low-Cutoff Filter:  Cut-Off Frequencies: 0.3, 1, 3, 10, 30, 100, 300, 500 Hz
Cut-Off Rate: 40dB/decade
High-Cutoff Filter:  Cut-Off Frequencies: 0.1, 0.3, 0.5, 1, 3, 5, 10, 20 kHz
Cut-Off Rate: 40dB/decade
Notch Filter:  Center Frequency: 50Hz or 60Hz
Rejection: >35dB
Gain:  13 values from x2 to x20,000
Click on a thumbnail image below to display a larger image.  Click again to restore the thumbnail.

AM-3500 Requirements
- A USB port is needed if the amplifier will be controlled using computer software

  Home     Products     Applications           Company Info     Site Map     What's New       Contact Us       

© 2018 DataWave Technologies, All Rights Reserved